Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Acura Integra Type R built from 1997 to 2001 (Type R, Type R).
Every 1997-2001 Acura Integra Type R uses a 5X114.3 bolt pattern with a 64.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 64.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M12x1.5. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Acura Integra Type R (DC2) and the model years each was sold. All of them share the 5X114.3 bolt pattern.
| Submodel | Years |
|---|---|
| Type R | 1997-1998 |
| Type R | 2000-2001 |
Wheel sizes Acura fitted to the 1997-2001 Acura Integra Type R from the factory. Offsets are ET in millimeters.
| Factory size |
|---|
| 15x6 +50 |
| 16x6.5 +55 |
| 17x7 +48 |
Widths and offsets with Verified Fitment on the 1997-2001 Acura Integra Type R: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Offset range |
|---|---|---|
| 15-17" | 6" | +33 to +55 |
| 15-17" | 6.5" | +39 to +49 |
Wider still: 15x7.5 +31 to +42; 16x7.5 +31 to +42; 17x7.5 +31 to +42 fit with modifications (roll front and rear fender lips, rear camber adjustment (camber kit) for wider/lower-offset wheels, hub-centric rings for aftermarket wheels).
In-stock PG WHEELS sets in sizes with Verified Fitment for the 1997-2001 Acura Integra Type R. Each card shows only the sizes that fit; prices are for a set of 4 with free shipping in the lower 48.
Modifications Required (roll front and rear fender lips, rear camber adjustment (camber kit) for wider/lower-offset wheels, hub-centric rings for aftermarket wheels)
The 1997-2001 Acura Integra Type R (DC2) uses a 5X114.3 bolt pattern and a 64.1 mm center bore.
Factory sizes: 15x6 +50; 16x6.5 +55; 17x7 +48.
Its wheel fasteners use a M12x1.5 thread.
Bolt-on sizes run from 15" to 17" in diameter; see the size table for the offset range at each width.