Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Acura TL built from 1996 to 1998.
Every 1996-1998 Acura TL uses a 5X114.3 bolt pattern with a 64.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 64.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M12x1.5. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Acura TL (3.2TL) and the model years each was sold. All of them share the 5X114.3 bolt pattern.
| Submodel | Years |
|---|---|
| 3.2TL | 1996-1998 |
Wheel sizes Acura fitted to the 1996-1998 Acura TL from the factory. Offsets are ET in millimeters.
| Factory size |
|---|
| 15x6.5 +55 |
| 16x7 +55 |
| 17x7.5 +50 |
| 18x8 +48 |
Widths and offsets with Verified Fitment on the 1996-1998 Acura TL: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Offset range |
|---|---|---|
| 15-17" | 6.5" | +38 to +60 |
| 15-17" | 7" | +44 to +54 |
Wider still: 15x8 +36 to +47; 16x8 +36 to +47; 17x8 +36 to +47 fit with modifications (roll rear fender lips, front camber bolts / rear camber arms for -1.5° or more, hub-centric rings for aftermarket wheels).
In-stock PG WHEELS sets in sizes with Verified Fitment for the 1996-1998 Acura TL. Each card shows only the sizes that fit; prices are for a set of 4 with free shipping in the lower 48.
Modifications Required (roll rear fender lips, front camber bolts / rear camber arms for -1.5° or more, hub-centric rings for aftermarket wheels)
The 1996-1998 Acura TL (3.2TL) uses a 5X114.3 bolt pattern and a 64.1 mm center bore.
Factory sizes: 15x6.5 +55; 16x7 +55; 17x7.5 +50; 18x8 +48.
Its wheel fasteners use a M12x1.5 thread.
Bolt-on sizes run from 15" to 17" in diameter; see the size table for the offset range at each width.