Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Acura TSX built from 2004 to 2008 (Base, Navigation).
Every 2004-2008 Acura TSX uses a 5X114.3 bolt pattern with a 64.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 64.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M12x1.5. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Acura TSX (1st Gen (CL9)) and the model years each was sold. All of them share the 5X114.3 bolt pattern.
| Submodel | Years |
|---|---|
| Base | 2004-2008 |
| Navigation | 2004-2008 |
Wheel sizes Acura fitted to the 2004-2008 Acura TSX from the factory. Offsets are ET in millimeters.
| Factory size |
|---|
| 17x7 +55 |
| 17x7.5 +55 |
| 18x7.5 +55 |
| 18x8 +50 |
Widths and offsets with Verified Fitment on the 2004-2008 Acura TSX: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Offset range |
|---|---|---|
| 17-18" | 7" | +14 to +65 |
| 17-18" | 7.5" | +21 to +60 |
| 17-18" | 8" | +27 to +54 |
| 17-18" | 8.5" | +33 to +47 |
Wider still: 17x9 +19 to +44; 17x9.5 +26 to +37; 18x9 +19 to +44; 18x9.5 +26 to +37 fit with modifications (roll the fender lips, add negative camber (camber bolts or arms), wheel alignment after install).
In-stock PG WHEELS sets in sizes with Verified Fitment for the 2004-2008 Acura TSX. Each card shows only the sizes that fit; prices are for a set of 4 with free shipping in the lower 48.












Modifications Required (roll the fender lips, add negative camber (camber bolts or arms), wheel alignment after install)
The 2004-2008 Acura TSX (1st Gen (CL9)) uses a 5X114.3 bolt pattern and a 64.1 mm center bore.
Factory sizes: 17x7 +55; 17x7.5 +55; 18x7.5 +55; 18x8 +50.
Its wheel fasteners use a M12x1.5 thread.
Bolt-on sizes run from 17" to 18" in diameter; see the size table for the offset range at each width.