Bolt pattern, center bore, factory wheel sizes for each submodel and the aftermarket widths and offsets that bolt on to the Audi 200 built from 1984 to 1991 (2.1 5E, 2.1 Turbo, 2.2 20V Turbo Quattro, 2.2 Turbo).
Every 1984-1991 Audi 200 uses a 5X112 bolt pattern with a 57.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 57.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M14x1.5. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Audi 200 (C3) and the model years each was sold. All of them share the 5X112 bolt pattern.
| Submodel | Years | Factory wheel sizes |
|---|---|---|
| 2.1 5E | 1984-1991 | 15x7 +35 15x7.5 +35 |
| 2.1 Turbo | 1984-1991 | 15x7 +35 15x7.5 +35 |
| 2.2 20V Turbo Quattro | 1984-1991 | 15x7 +35 15x7.5 +35 |
| 2.2 Turbo | 1984-1991 | 15x7 +35 15x7.5 +35 |
Wheel sizes Audi fitted to the 1984-1991 Audi 200 from the factory (all submodels; the table above lists them by submodel). Offsets are ET in millimeters.
| Factory size |
|---|
| 15x7 +35 |
| 15x7.5 +35 |
Widths and offsets with Verified Fitment on the 1984-1991 Audi 200: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Offset range |
|---|---|---|
| 15-16" | 7" | +18 to +41 |
| 15-16" | 7.5" | +24 to +34 |
Wider still: 15x8.5 +16 to +27; 16x8.5 +16 to +27 fit with modifications (roll rear fender lips, adjustable camber parts for extra negative camber, hub-centric rings (57.1 mm), correct-length ball-seat lug bolts).
The 1984-1991 Audi 200 (C3) uses a 5X112 bolt pattern and a 57.1 mm center bore.
Factory sizes: 15x7 +35; 15x7.5 +35.
Its wheel fasteners use a M14x1.5 thread.
Bolt-on sizes run from 15" to 16" in diameter; see the size table for the offset range at each width.