Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Audi Coupe Quattro built from 1990 to 1991.
Every 1990-1991 Audi Coupe Quattro uses a 4X108 bolt pattern with a 57.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 57.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Audi Coupe Quattro (B3) and the model years each was sold. All of them share the 4X108 bolt pattern.
| Submodel | Years |
|---|---|
| Base | 1990-1991 |
Wheel sizes Audi fitted to the 1990-1991 Audi Coupe Quattro from the factory. Offsets are ET in millimeters.
| Factory size |
|---|
| 15x6.5 +41 |
| 15x7 +37 |
| 16x7.5 +35 |
Widths and offsets with Verified Fitment on the 1990-1991 Audi Coupe Quattro: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Offset range |
|---|---|---|
| 15-17" | 6.5" | +24 to +46 |
| 15-17" | 7" | +30 to +40 |
Wider still: 15x8 +22 to +33; 16x8 +22 to +33; 17x8 +22 to +33 fit with modifications (roll rear fender lips, adjustable camber parts for extra negative camber, hub-centric rings (57.1 mm), correct-length ball-seat lug bolts).
The 1990-1991 Audi Coupe Quattro (B3) uses a 4X108 bolt pattern and a 57.1 mm center bore.
Factory sizes: 15x6.5 +41; 15x7 +37; 16x7.5 +35.
Bolt-on sizes run from 15" to 17" in diameter; see the size table for the offset range at each width.