Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Audi Q3 built from 2019 to 2025 (Premium, Premium Plus, Prestige).
Every 2019-2025 Audi Q3 uses a 5X112 bolt pattern with a 57.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 57.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M14x1.5. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Audi Q3 (F3) and the model years each was sold. All of them share the 5X112 bolt pattern.
| Submodel | Years |
|---|---|
| Premium | 2019-2025 |
| Premium Plus | 2019-2025 |
| Prestige | 2019-2020 |
Wheel sizes Audi fitted to the 2019-2025 Audi Q3 from the factory. Offsets are ET in millimeters.
| Factory size |
|---|
| 17x6.5 +38 |
| 17x7 +40 |
| 18x7 +43 |
| 19x7 +43 |
| 19x8.5 +38 |
| 20x8.5 +38 |
Widths and offsets with Verified Fitment on the 2019-2025 Audi Q3: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Offset range |
|---|---|---|
| 17-22" | 7" | +21 to +51 |
| 17-22" | 7.5" | +28 to +44 |
| 17-22" | 8" | +34 to +38 |
In-stock PG WHEELS sets in sizes with Verified Fitment for the 2019-2025 Audi Q3. Each card shows only the sizes that fit; prices are for a set of 4 with free shipping in the lower 48.









Modifications Required (trim front wheel-well liner / bumper cover tabs, hub-centric rings (57.1 mm), check strut and spring clearance on the inner edge, longer ball-seat lug bolts with spacers)










The 2019-2025 Audi Q3 (F3) uses a 5X112 bolt pattern and a 57.1 mm center bore.
Factory sizes: 17x6.5 +38; 17x7 +40; 18x7 +43; 19x7 +43; 19x8.5 +38; 20x8.5 +38.
Its wheel fasteners use a M14x1.5 thread.
Bolt-on sizes run from 17" to 22" in diameter; see the size table for the offset range at each width.