Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Audi RS e-tron GT built from 2022 to 2022.
Every 2022 Audi RS e-tron GT uses a 5X130 bolt pattern with a 71.6 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 71.6 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M14x1.5. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Audi RS e-tron GT (1st Gen) and the model years each was sold. All of them share the 5X130 bolt pattern.
| Submodel | Years |
|---|---|
| Base | 2022 |
Wheel sizes Audi fitted to the 2022 Audi RS e-tron GT from the factory. Offsets are ET in millimeters.
| Factory size |
|---|
| 20x9 +54 front / 20x11 +60 rear |
| 21x9.5 +60 front / 21x11.5 +66 rear |
Widths and offsets with Verified Fitment on the 2022 Audi RS e-tron GT: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Front offset | Rear offset |
|---|---|---|---|
| 20-22" | 9" | +37 to +60 | — |
| 20-22" | 9.5" | +43 to +53 | — |
| 20-22" | 11" | — | +43 to +66 |
| 20-22" | 11.5" | — | +49 to +59 |
Wider still: 20x12.5 front — / rear +41 to +52; 21x12.5 front — / rear +41 to +52; 22x12.5 front — / rear +41 to +52 fit with modifications (roll rear fender lips, adjustable camber parts for extra negative camber, hub-centric rings (71.6 mm), correct-length ball-seat lug bolts).
In-stock PG WHEELS sets in sizes with Verified Fitment for the 2022 Audi RS e-tron GT. Each card shows only the sizes that fit; prices are for a set of 4 with free shipping in the lower 48.
Modifications Required (roll rear fender lips, adjustable camber parts for extra negative camber, hub-centric rings (71.6 mm), correct-length ball-seat lug bolts)
The 2022 Audi RS e-tron GT (1st Gen) uses a 5X130 bolt pattern and a 71.6 mm center bore.
Factory sizes: 20x9 +54 front / 20x11 +60 rear; 21x9.5 +60 front / 21x11.5 +66 rear.
Its wheel fasteners use a M14x1.5 thread.
Bolt-on sizes run from 20" to 22" in diameter; see the size table for the offset range at each width.