Bolt pattern, center bore, factory wheel sizes for each submodel and the aftermarket widths and offsets that bolt on to the Audi S3 built from 2022 to 2026.
Every 2022-2026 Audi S3 uses a 5X112 bolt pattern with a 57.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 57.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M14x1.5. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Audi S3 (8Y) and the model years each was sold. All of them share the 5X112 bolt pattern.
| Submodel | Years | Factory wheel sizes |
|---|---|---|
| Base | 2022-2026 | 19x8 +49 |
Wheel sizes Audi fitted to the 2022-2026 Audi S3 from the factory (all submodels; the table above lists them by submodel). Offsets are ET in millimeters.
| Factory size |
|---|
| 17x6.5 +43 |
| 17x8 +46 |
| 18x7.5 +51 |
| 18x8 +46 |
| 19x8 +49 |
Widths and offsets with Verified Fitment on the 2022-2026 Audi S3: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Offset range |
|---|---|---|
| 19-20" | 8" | +29 to +54 |
| 19-20" | 8.5" | +35 to +48 |
| 19-20" | 9" | +42 |
Wider still: 19x9.5 +27 to +41; 19x10 +34 to +35; 20x9.5 +27 to +41; 20x10 +34 to +35 fit with modifications (roll the fender lips, add negative camber (camber bolts or arms), wheel alignment after install).
In-stock PG WHEELS sets in sizes with Verified Fitment for the 2022-2026 Audi S3. Each card shows only the sizes that fit; prices are for a set of 4 with free shipping in the lower 48.







Modifications Required (roll the fender lips, add negative camber (camber bolts or arms), wheel alignment after install)












The 2022-2026 Audi S3 (8Y) uses a 5X112 bolt pattern and a 57.1 mm center bore.
Factory sizes: 17x6.5 +43; 17x8 +46; 18x7.5 +51; 18x8 +46; 19x8 +49.
Its wheel fasteners use a M14x1.5 thread.
Bolt-on sizes run from 19" to 20" in diameter; see the size table for the offset range at each width.