Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Audi S8 built from 2013 to 2018 (Base, Plus).
Every 2013-2018 Audi S8 uses a 5X112 bolt pattern with a 66.5 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 66.5 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M14x1.5. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Audi S8 (D4) and the model years each was sold. All of them share the 5X112 bolt pattern.
| Submodel | Years |
|---|---|
| Base | 2013-2016 |
| Plus | 2016-2018 |
Wheel sizes Audi fitted to the 2013-2018 Audi S8 from the factory. Offsets are ET in millimeters.
| Factory size |
|---|
| 20x9 +37 |
| 21x9 +35 |
| 22x9.5 +32 |
| 22x10 +28 |
Widths and offsets with Verified Fitment on the 2013-2018 Audi S8: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Offset range |
|---|---|---|
| 20-23" | 9" | +18 to +41 |
| 20-23" | 9.5" | +24 to +34 |
Wider still: 20x10.5 +16 to +27; 21x10.5 +16 to +27; 22x10.5 +16 to +27; 23x10.5 +16 to +27 fit with modifications (roll rear fender lips, adjustable camber parts for extra negative camber, hub-centric rings (66.5 mm), correct-length ball-seat lug bolts).
In-stock PG WHEELS sets in sizes with Verified Fitment for the 2013-2018 Audi S8. Each card shows only the sizes that fit; prices are for a set of 4 with free shipping in the lower 48.






Modifications Required (roll rear fender lips, adjustable camber parts for extra negative camber, hub-centric rings (66.5 mm), correct-length ball-seat lug bolts)





The 2013-2018 Audi S8 (D4) uses a 5X112 bolt pattern and a 66.5 mm center bore.
Factory sizes: 20x9 +37; 21x9 +35; 22x9.5 +32; 22x10 +28.
Its wheel fasteners use a M14x1.5 thread.
Bolt-on sizes run from 20" to 23" in diameter; see the size table for the offset range at each width.