BMW 1M Coupe (E82) 2011 Wheel Fitment Guide

Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the BMW 1M Coupe built from 2011 to 2011.

Fitment specs

Bolt pattern5X120
Center bore72.6 mm
Model years2011
GenerationE82

Every 2011 BMW 1M Coupe uses a 5X120 bolt pattern with a 72.6 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 72.6 mm inner diameter so the wheel centers on the hub instead of the lugs. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.

Years & submodels

US-market submodels of the BMW 1M Coupe (E82) and the model years each was sold. All of them share the 5X120 bolt pattern.

SubmodelYears
Base2011

Factory wheel sizes

Wheel sizes BMW fitted to the 2011 BMW 1M Coupe from the factory. Offsets are ET in millimeters.

Factory size
19x9 +31 front / 19x10 +25 rear

Aftermarket sizes that bolt on

Widths and offsets with Verified Fitment on the 2011 BMW 1M Coupe: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.

DiameterWidthFront offsetRear offset
19-20"9"+14 to +37—
19-20"9.5"+20 to +30—
19-20"10"—+8 to +31
19-20"10.5"—+14 to +24

Wider still: 19x11.5 front — / rear +6 to +17; 20x11.5 front — / rear +6 to +17 fit with modifications (roll rear fender lips, adjustable rear camber arms for -1.5° or more, front camber plates, hub-centric rings if wheel bore is larger than the hub).

Wheels in stock that fit

In-stock PG WHEELS sets in sizes with Verified Fitment for the 2011 BMW 1M Coupe. Each card shows only the sizes that fit; prices are for a set of 4 with free shipping in the lower 48.

Modifications Required (roll rear fender lips, adjustable rear camber arms for -1.5° or more, front camber plates, hub-centric rings if wheel bore is larger than the hub)

FAQ

What is the bolt pattern of the 2011 BMW 1M Coupe?

The 2011 BMW 1M Coupe (E82) uses a 5X120 bolt pattern and a 72.6 mm center bore.

What size wheels came on the 2011 BMW 1M Coupe from the factory?

Factory sizes: 19x9 +31 front / 19x10 +25 rear.

What aftermarket wheel sizes fit the 2011 BMW 1M Coupe without modifications?

Bolt-on sizes run from 19" to 20" in diameter; see the size table for the offset range at each width.