Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the BMW i8 built from 2014 to 2020 (Coupe, Roadster).
Every 2014-2020 BMW i8 uses a 5X112 bolt pattern with a 66.6 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 66.6 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M14x1.25. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the BMW i8 (I12/I15) and the model years each was sold. All of them share the 5X112 bolt pattern.
| Submodel | Years |
|---|---|
| Coupe | 2014-2020 |
| Roadster | 2019-2020 |
Wheel sizes BMW fitted to the 2014-2020 BMW i8 from the factory. Offsets are ET in millimeters.
| Factory size |
|---|
| 20x7 +36 front / 20x7.5 +40 rear |
| 20x7.5 +40 |
| 20x7.5 +40 front / 20x8.5 +50 rear |
Widths and offsets with Verified Fitment on the 2014-2020 BMW i8: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Front offset | Rear offset |
|---|---|---|---|
| 20-21" | 7" | +16 to +46 | — |
| 20-21" | 7.5" | +23 to +45 | +20 to +50 |
| 20-21" | 8" | +29 to +39 | +26 to +56 |
| 20-21" | 8.5" | — | +33 to +55 |
| 20-21" | 9" | — | +39 to +49 |
Wider still: 20x10 front — / rear +31 to +42; 21x10 front — / rear +31 to +42 fit with modifications (roll rear fender lips, adjustable rear camber arms for -1.5° or more, front camber plates, hub-centric rings if wheel bore is larger than the hub).
In-stock PG WHEELS sets in sizes with Verified Fitment for the 2014-2020 BMW i8. Each card shows only the sizes that fit; prices are for a set of 4 with free shipping in the lower 48.
Modifications Required (roll rear fender lips, adjustable rear camber arms for -1.5° or more, front camber plates, hub-centric rings if wheel bore is larger than the hub)










The 2014-2020 BMW i8 (I12/I15) uses a 5X112 bolt pattern and a 66.6 mm center bore.
Factory sizes: 20x7 +36 front / 20x7.5 +40 rear; 20x7.5 +40; 20x7.5 +40 front / 20x8.5 +50 rear.
Its wheel fasteners use a M14x1.25 thread.
Bolt-on sizes run from 20" to 21" in diameter; see the size table for the offset range at each width.