Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Cadillac ELR built from 2014 to 2014.
Every 2014 Cadillac ELR uses a 5X115 bolt pattern with a 70.3 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 70.3 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M12x1.5. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Cadillac ELR (1st Gen) and the model years each was sold. All of them share the 5X115 bolt pattern.
| Submodel | Years |
|---|---|
| Base | 2014 |
Wheel sizes Cadillac fitted to the 2014 Cadillac ELR from the factory. Offsets are ET in millimeters.
| Factory size |
|---|
| 20x8.5 +41 |
| 21x8.5 +41 |
| 22x9 +37 |
Widths and offsets with Verified Fitment on the 2014 Cadillac ELR: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Offset range |
|---|---|---|
| 20-23" | 8.5" | +24 to +46 |
| 20-23" | 9" | +30 to +40 |
Wider still: 20x10 +22 to +33; 21x10 +22 to +33; 22x10 +22 to +33; 23x10 +22 to +33 fit with modifications (roll front and rear fender lips, front camber bolts for -1° or more, hub-centric rings for aftermarket wheels).
In-stock PG WHEELS sets in sizes with Verified Fitment for the 2014 Cadillac ELR. Each card shows only the sizes that fit; prices are for a set of 4 with free shipping in the lower 48.
Modifications Required (roll front and rear fender lips, front camber bolts for -1° or more, hub-centric rings for aftermarket wheels)
The 2014 Cadillac ELR (1st Gen) uses a 5X115 bolt pattern and a 70.3 mm center bore.
Factory sizes: 20x8.5 +41; 21x8.5 +41; 22x9 +37.
Its wheel fasteners use a M12x1.5 thread.
Bolt-on sizes run from 20" to 23" in diameter; see the size table for the offset range at each width.