Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Chevrolet S-10 Blazer built from 1983 to 1994 (Base, Tahoe, Tahoe LT).
Every 1983-1994 Chevrolet S-10 Blazer uses a 5X120.65 bolt pattern with a 70.3 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 70.3 mm inner diameter so the wheel centers on the hub instead of the lugs. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Chevrolet S-10 Blazer (1st Gen) and the model years each was sold. All of them share the 5X120.65 bolt pattern.
| Submodel | Years |
|---|---|
| Base | 1983-1994 |
| Tahoe | 1983-1991 |
| Tahoe LT | 1991-1994 |
Wheel sizes Chevrolet fitted to the 1983-1994 Chevrolet S-10 Blazer from the factory. Offsets are ET in millimeters.
| Factory size |
|---|
| 15x7 +50 |
Widths and offsets with Verified Fitment on the 1983-1994 Chevrolet S-10 Blazer: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Offset range |
|---|---|---|
| 15-18" | 7" | +33 to +55 |
| 15-18" | 7.5" | +39 to +49 |
Wider still: 15x8.5 +31 to +42; 16x8.5 +31 to +42; 17x8.5 +31 to +42; 18x8.5 +31 to +42 fit with modifications (torsion-bar / front leveling for larger tires (4wd), trim front bumper valance and inner fender liner, hub-centric rings for aftermarket wheels).
The 1983-1994 Chevrolet S-10 Blazer (1st Gen) uses a 5X120.65 bolt pattern and a 70.3 mm center bore.
Factory sizes: 15x7 +50.
Bolt-on sizes run from 15" to 18" in diameter; see the size table for the offset range at each width.