Chrysler 300 SRT8 (LX) 2005-2010 Wheel Fitment Guide

Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Chrysler 300 SRT8 built from 2005 to 2010.

Fitment specs

Bolt pattern5X115
Center bore71.5 mm
Model years2005-2010
GenerationLX

Every 2005-2010 Chrysler 300 SRT8 uses a 5X115 bolt pattern with a 71.5 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 71.5 mm inner diameter so the wheel centers on the hub instead of the lugs. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.

Years & submodels

US-market submodels of the Chrysler 300 SRT8 (LX) and the model years each was sold. All of them share the 5X115 bolt pattern.

SubmodelYears
SRT82005-2010

Factory wheel sizes

Wheel sizes Chrysler fitted to the 2005-2010 Chrysler 300 SRT8 from the factory. Offsets are ET in millimeters.

Factory size
20x9 +25.5
21x9 +20 front / 21x9.5 +20 rear
22x9 +20 front / 22x10 +15 rear

Aftermarket sizes that bolt on

Widths and offsets with Verified Fitment on the 2005-2010 Chrysler 300 SRT8: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.

DiameterWidthOffset range
20-22"9"+8 to +31
20-22"9.5"+15 to +25

Wider still: 20x10.5 +7 to +18; 21x10.5 +7 to +18; 22x10.5 +7 to +18 fit with modifications (roll rear fender lips, check strut / spring clearance up front (spacer may be needed), rear fender roll or pull for wide, low-offset rear wheels).

Wheels in stock that fit

In-stock PG WHEELS sets in sizes with Verified Fitment for the 2005-2010 Chrysler 300 SRT8. Each card shows only the sizes that fit; prices are for a set of 4 with free shipping in the lower 48.

FAQ

What is the bolt pattern of the 2005-2010 Chrysler 300 SRT8?

The 2005-2010 Chrysler 300 SRT8 (LX) uses a 5X115 bolt pattern and a 71.5 mm center bore.

What size wheels came on the 2005-2010 Chrysler 300 SRT8 from the factory?

Factory sizes: 20x9 +25.5; 21x9 +20 front / 21x9.5 +20 rear; 22x9 +20 front / 22x10 +15 rear.

What aftermarket wheel sizes fit the 2005-2010 Chrysler 300 SRT8 without modifications?

Bolt-on sizes run from 20" to 22" in diameter; see the size table for the offset range at each width.