Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Chrysler 300M built from 1999 to 2004 (Base, Special).
Every 1999-2004 Chrysler 300M uses a 5X114.3 bolt pattern with a 71.5 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 71.5 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M12x1.5. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Chrysler 300M (LH) and the model years each was sold. All of them share the 5X114.3 bolt pattern.
| Submodel | Years |
|---|---|
| Base | 1999-2004 |
| Special | 2002-2004 |
Wheel sizes Chrysler fitted to the 1999-2004 Chrysler 300M from the factory. Offsets are ET in millimeters.
| Factory size |
|---|
| 16x7 +43 |
| 17x7 +43 |
| 18x7.5 +43 |
| 18x8 +41 |
| 19x8 +38 |
| 19x8 +41 |
Widths and offsets with Verified Fitment on the 1999-2004 Chrysler 300M: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Offset range |
|---|---|---|
| 16-19" | 7" | +26 to +48 |
| 16-19" | 7.5" | +32 to +42 |
Wider still: 16x8.5 +24 to +35; 17x8.5 +24 to +35; 18x8.5 +24 to +35; 19x8.5 +24 to +35 fit with modifications (roll front and rear fender lips, front camber bolts for added negative camber, trim front fender liner if it rubs at full lock).
In-stock PG WHEELS sets in sizes with Verified Fitment for the 1999-2004 Chrysler 300M. Each card shows only the sizes that fit; prices are for a set of 4 with free shipping in the lower 48.
Modifications Required (roll front and rear fender lips, front camber bolts for added negative camber, trim front fender liner if it rubs at full lock)












The 1999-2004 Chrysler 300M (LH) uses a 5X114.3 bolt pattern and a 71.5 mm center bore.
Factory sizes: 16x7 +43; 17x7 +43; 18x7.5 +43; 18x8 +41; 19x8 +38; 19x8 +41.
Its wheel fasteners use a M12x1.5 thread.
Bolt-on sizes run from 16" to 19" in diameter; see the size table for the offset range at each width.