Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Chrysler Aspen built from 2007 to 2009 (Limited, Hybrid).
Every 2007-2009 Chrysler Aspen uses a 5X139.7 bolt pattern with a 77.8 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 77.8 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is 9/16"-18UNF. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Chrysler Aspen (HG) and the model years each was sold. All of them share the 5X139.7 bolt pattern.
| Submodel | Years |
|---|---|
| Limited | 2007-2009 |
| Hybrid | 2009 |
Wheel sizes Chrysler fitted to the 2007-2009 Chrysler Aspen from the factory. Offsets are ET in millimeters.
| Factory size |
|---|
| 17x7.5 +35 |
| 18x8 +35 |
| 19x8 +35 |
| 20x8 +30 |
| 20x8 +35 |
| 21x8.5 +30 |
| 22x9 +25 |
Widths and offsets with Verified Fitment on the 2007-2009 Chrysler Aspen: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Offset range |
|---|---|---|
| 17-22" | 7.5" | +18 to +40 |
| 17-22" | 8" | +24 to +34 |
Wider still: 17x9 +16 to +27; 18x9 +16 to +27; 19x9 +16 to +27; 20x9 +16 to +27; 21x9 +16 to +27; 22x9 +16 to +27 fit with modifications (leveling kit or small lift for larger tires, trim front fender liner and air dam, check upper control arm / sway bar clearance).
The 2007-2009 Chrysler Aspen (HG) uses a 5X139.7 bolt pattern and a 77.8 mm center bore.
Factory sizes: 17x7.5 +35; 18x8 +35; 19x8 +35; 20x8 +30; 20x8 +35; 21x8.5 +30; 22x9 +25.
Its wheel fasteners use a 9/16"-18UNF thread.
Bolt-on sizes run from 17" to 22" in diameter; see the size table for the offset range at each width.