Chrysler Concorde (LH) 1993-1997 Wheel Fitment Guide

Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Chrysler Concorde built from 1993 to 1997 (Base, LX, LXi).

Fitment specs

Bolt pattern5X114.3
Center bore71.5 mm
Lug threadM12x1.5
Model years1993-1997
GenerationLH

Every 1993-1997 Chrysler Concorde uses a 5X114.3 bolt pattern with a 71.5 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 71.5 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M12x1.5. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.

Years & submodels

US-market submodels of the Chrysler Concorde (LH) and the model years each was sold. All of them share the 5X114.3 bolt pattern.

SubmodelYears
Base1993-1997
LX1997
LXi1997

Factory wheel sizes

Wheel sizes Chrysler fitted to the 1993-1997 Chrysler Concorde from the factory. Offsets are ET in millimeters.

Factory size
15x6 +39
16x6.5 +40
16x7 +40
16x7 +43
17x7 +40
17x7 +43
18x7 +43
19x7.5 +40

Aftermarket sizes that bolt on

Widths and offsets with Verified Fitment on the 1993-1997 Chrysler Concorde: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.

DiameterWidthOffset range
15-17"6"+13 to +49
15-17"6.5"+20 to +55
15-17"7"+26 to +48
15-17"7.5"+32 to +42

Wider still: 15x8.5 +24 to +35; 16x8.5 +24 to +35; 17x8.5 +24 to +35 fit with modifications (roll front and rear fender lips, front camber bolts for added negative camber, trim front fender liner if it rubs at full lock).

Wheels in stock that fit

In-stock PG WHEELS sets in sizes with Verified Fitment for the 1993-1997 Chrysler Concorde. Each card shows only the sizes that fit; prices are for a set of 4 with free shipping in the lower 48.

FAQ

What is the bolt pattern of the 1993-1997 Chrysler Concorde?

The 1993-1997 Chrysler Concorde (LH) uses a 5X114.3 bolt pattern and a 71.5 mm center bore.

What size wheels came on the 1993-1997 Chrysler Concorde from the factory?

Factory sizes: 15x6 +39; 16x6.5 +40; 16x7 +40; 16x7 +43; 17x7 +40; 17x7 +43; 18x7 +43; 19x7.5 +40.

What lug thread size does the 1993-1997 Chrysler Concorde use?

Its wheel fasteners use a M12x1.5 thread.

What aftermarket wheel sizes fit the 1993-1997 Chrysler Concorde without modifications?

Bolt-on sizes run from 15" to 17" in diameter; see the size table for the offset range at each width.