Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Chrysler Imperial built from 1990 to 1993.
Every 1990-1993 Chrysler Imperial uses a 5X100 bolt pattern with a 57.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 57.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Chrysler Imperial (Y-body) and the model years each was sold. All of them share the 5X100 bolt pattern.
| Submodel | Years |
|---|---|
| Base | 1990-1993 |
Wheel sizes Chrysler fitted to the 1990-1993 Chrysler Imperial from the factory. Offsets are ET in millimeters.
| Factory size |
|---|
| 14x5.5 +40 |
Widths and offsets with Verified Fitment on the 1990-1993 Chrysler Imperial: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Offset range |
|---|---|---|
| 14-15" | 5.5" | +23 to +45 |
| 14-15" | 6" | +29 to +39 |
Wider still: 14x7 +21 to +32; 15x7 +21 to +32 fit with modifications (roll the fender lips, add negative camber (camber bolts or arms), wheel alignment after install).
The 1990-1993 Chrysler Imperial (Y-body) uses a 5X100 bolt pattern and a 57.1 mm center bore.
Factory sizes: 14x5.5 +40.
Bolt-on sizes run from 14" to 15" in diameter; see the size table for the offset range at each width.