Chrysler Sebring Convertible (JX) 1996-2000 Wheel Fitment Guide

Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Chrysler Sebring Convertible built from 1996 to 2000 (JX, JXi, Limited).

Fitment specs

Bolt pattern5X100
Center bore57.1 mm
Model years1996-2000
GenerationJX

Every 1996-2000 Chrysler Sebring Convertible uses a 5X100 bolt pattern with a 57.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 57.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.

Years & submodels

US-market submodels of the Chrysler Sebring Convertible (JX) and the model years each was sold. All of them share the 5X100 bolt pattern.

SubmodelYears
JX1996-2000
JXi1996-2000
Limited1999-2000

Factory wheel sizes

Wheel sizes Chrysler fitted to the 1996-2000 Chrysler Sebring Convertible from the factory. Offsets are ET in millimeters.

Factory size
14x5.5 +37
15x6 +41
16x6.5 +44
16x7 +45
17x6.5 +44
17x7 +42
17x7 +45
17x7.5 +42
18x8 +38

Aftermarket sizes that bolt on

Widths and offsets with Verified Fitment on the 1996-2000 Chrysler Sebring Convertible: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.

DiameterWidthOffset range
14-18"5.5"+14 to +47
14-18"6"+20 to +53
14-18"6.5"+27 to +49
14-18"7"+33 to +43

Wider still: 14x8 +25 to +36; 15x8 +25 to +36; 16x8 +25 to +36; 17x8 +25 to +36; 18x8 +25 to +36 fit with modifications (roll front and rear fender lips, front camber bolts for added negative camber, trim front fender liner if it rubs at full lock).

FAQ

What is the bolt pattern of the 1996-2000 Chrysler Sebring Convertible?

The 1996-2000 Chrysler Sebring Convertible (JX) uses a 5X100 bolt pattern and a 57.1 mm center bore.

What size wheels came on the 1996-2000 Chrysler Sebring Convertible from the factory?

Factory sizes: 14x5.5 +37; 15x6 +41; 16x6.5 +44; 16x7 +45; 17x6.5 +44; 17x7 +42; 17x7 +45; 17x7.5 +42; 18x8 +38.

What aftermarket wheel sizes fit the 1996-2000 Chrysler Sebring Convertible without modifications?

Bolt-on sizes run from 14" to 18" in diameter; see the size table for the offset range at each width.