Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Dodge Colt built from 1989 to 1992.
Every 1989-1992 Dodge Colt uses a 4X100 bolt pattern with a 56.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 56.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M12x1.5. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Dodge Colt and the model years each was sold. All of them share the 4X100 bolt pattern.
| Submodel | Years |
|---|---|
| Base | 1989-1992 |
Wheel sizes Dodge fitted to the 1989-1992 Dodge Colt from the factory. Offsets are ET in millimeters.
| Factory size |
|---|
| 13x4.5 +46 |
| 13x5 +46 |
| 14x5.5 +46 |
Widths and offsets with Verified Fitment on the 1989-1992 Dodge Colt: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Offset range |
|---|---|---|
| 13-15" | 4.5" | +16 to +56 |
| 13-15" | 5" | +22 to +58 |
| 13-15" | 5.5" | +29 to +51 |
| 13-15" | 6" | +35 to +45 |
Wider still: 13x7 +27 to +38; 14x7 +27 to +38; 15x7 +27 to +38 fit with modifications (roll front and rear fender lips, front camber bolts for -1° or more, hub-centric rings for aftermarket wheels).
The 1989-1992 Dodge Colt uses a 4X100 bolt pattern and a 56.1 mm center bore.
Factory sizes: 13x4.5 +46; 13x5 +46; 14x5.5 +46.
Its wheel fasteners use a M12x1.5 thread.
Bolt-on sizes run from 13" to 15" in diameter; see the size table for the offset range at each width.