Ford Bronco II 1st Gen 1984-1990 Wheel Fitment Guide

Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Ford Bronco II built from 1984 to 1990 (Base, XL, XLS, XLT, Eddie Bauer).

Fitment specs

Bolt pattern5X114.3
Center bore70.6 mm
Model years1984-1990
Generation1st Gen

Every 1984-1990 Ford Bronco II uses a 5X114.3 bolt pattern with a 70.6 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 70.6 mm inner diameter so the wheel centers on the hub instead of the lugs. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.

Years & submodels

US-market submodels of the Ford Bronco II (1st Gen) and the model years each was sold. All of them share the 5X114.3 bolt pattern.

SubmodelYears
Base1984-1990
XL1984-1990
XLS1986-1990
XLT1984-1990
Eddie Bauer1984-1990

Factory wheel sizes

Wheel sizes Ford fitted to the 1984-1990 Ford Bronco II from the factory. Offsets are ET in millimeters.

Factory size
15x6.5 +2

Aftermarket sizes that bolt on

Widths and offsets with Verified Fitment on the 1984-1990 Ford Bronco II: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.

DiameterWidthOffset range
15-17"6.5"-15 to +7
15-17"7"-9 to +1

Wider still: 15x8 -17 to -6; 16x8 -17 to -6; 17x8 -17 to -6 fit with modifications (leveling kit or small lift for larger tires, trim front fender liner and air dam, check upper control arm / sway bar clearance).

FAQ

What is the bolt pattern of the 1984-1990 Ford Bronco II?

The 1984-1990 Ford Bronco II (1st Gen) uses a 5X114.3 bolt pattern and a 70.6 mm center bore.

What size wheels came on the 1984-1990 Ford Bronco II from the factory?

Factory sizes: 15x6.5 +2.

What aftermarket wheel sizes fit the 1984-1990 Ford Bronco II without modifications?

Bolt-on sizes run from 15" to 17" in diameter; see the size table for the offset range at each width.