Ford Edge (U387) 2007-2010 Wheel Fitment Guide

Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Ford Edge built from 2007 to 2010 (SE, SEL, Limited, Sport).

Fitment specs

Bolt pattern5X114.3
Center bore70.5 mm
Lug thread1/2"-20UNF
Model years2007-2010
GenerationU387

Every 2007-2010 Ford Edge uses a 5X114.3 bolt pattern with a 70.5 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 70.5 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is 1/2"-20UNF. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.

Years & submodels

US-market submodels of the Ford Edge (U387) and the model years each was sold. All of them share the 5X114.3 bolt pattern.

SubmodelYears
SE2007-2010
SEL2007-2010
Limited2007-2010
Sport2009-2010

Factory wheel sizes

Wheel sizes Ford fitted to the 2007-2010 Ford Edge from the factory. Offsets are ET in millimeters.

Factory size
17x7.5 +40
18x7.5 +44
19x7.5 +44
19x8 +42
20x7.5 +44
20x8.5 +42
22x9 +35
22x9 +39

Aftermarket sizes that bolt on

Widths and offsets with Verified Fitment on the 2007-2010 Ford Edge: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.

DiameterWidthOffset range
17-22"7.5"+23 to +45
17-22"8"+29 to +39

Wider still: 17x9 +21 to +32; 18x9 +21 to +32; 19x9 +21 to +32; 20x9 +21 to +32; 21x9 +21 to +32; 22x9 +21 to +32 fit with modifications (roll fender lips, trim front fender liner and bumper cover edge, camber correction kit for wider wheels).

Wheels in stock that fit

In-stock PG WHEELS sets in sizes with Verified Fitment for the 2007-2010 Ford Edge. Each card shows only the sizes that fit; prices are for a set of 4 with free shipping in the lower 48.

Modifications Required (roll fender lips, trim front fender liner and bumper cover edge, camber correction kit for wider wheels)

FAQ

What is the bolt pattern of the 2007-2010 Ford Edge?

The 2007-2010 Ford Edge (U387) uses a 5X114.3 bolt pattern and a 70.5 mm center bore.

What size wheels came on the 2007-2010 Ford Edge from the factory?

Factory sizes: 17x7.5 +40; 18x7.5 +44; 19x7.5 +44; 19x8 +42; 20x7.5 +44; 20x8.5 +42; 22x9 +35; 22x9 +39.

What lug thread size does the 2007-2010 Ford Edge use?

Its wheel fasteners use a 1/2"-20UNF thread.

What aftermarket wheel sizes fit the 2007-2010 Ford Edge without modifications?

Bolt-on sizes run from 17" to 22" in diameter; see the size table for the offset range at each width.