Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Ford F-350 built from 1987 to 1991 (Custom, XL, XLT, XLT Lariat).
Every 1987-1991 Ford F-350 uses a 8X165.1 bolt pattern with a 124.9 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 124.9 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is N/A. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Ford F-350 (8th Gen) and the model years each was sold. All of them share the 8X165.1 bolt pattern.
| Submodel | Years |
|---|---|
| Custom | 1987-1991 |
| XL | 1987-1991 |
| XLT | 1987-1991 |
| XLT Lariat | 1987-1991 |
Wheel sizes Ford fitted to the 1987-1991 Ford F-350 from the factory. Offsets are ET in millimeters.
| Factory size |
|---|
| 16x7 +0 |
| 16x7.5 +0 |
Widths and offsets with Verified Fitment on the 1987-1991 Ford F-350: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Offset range |
|---|---|---|
| 16-18" | 7" | -17 to +5 |
| 16-18" | 7.5" | -11 to -1 |
Wider still: 16x8.5 -19 to -8; 17x8.5 -19 to -8; 18x8.5 -19 to -8 fit with modifications (leveling kit or lift, trim the fender liners and mud flaps, wheel alignment after install).
The 1987-1991 Ford F-350 (8th Gen) uses a 8X165.1 bolt pattern and a 124.9 mm center bore.
Factory sizes: 16x7 +0; 16x7.5 +0.
Its wheel fasteners use a N/A thread.
Bolt-on sizes run from 16" to 18" in diameter; see the size table for the offset range at each width.