Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the GMC Terrain built from 2011 to 2013 (SLE, SLT, Denali).
Every 2011-2013 GMC Terrain uses a 5X120 bolt pattern with a 67.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 67.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M14x1.5. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the GMC Terrain (Theta) and the model years each was sold. All of them share the 5X120 bolt pattern.
| Submodel | Years |
|---|---|
| SLE | 2011-2013 |
| SLT | 2011-2013 |
| Denali | 2013 |
Wheel sizes GMC fitted to the 2011-2013 GMC Terrain from the factory. Offsets are ET in millimeters.
| Factory size |
|---|
| 17x7 +43 |
| 17x7 +46 |
| 18x7 +46 |
| 19x7 +46 |
| 19x7 +50 |
| 19x7.5 +43 |
| 20x7.5 +43 |
| 20x8 +35 |
Widths and offsets with Verified Fitment on the 2011-2013 GMC Terrain: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Offset range |
|---|---|---|
| 17-20" | 7" | +29 to +51 |
| 17-20" | 7.5" | +35 to +45 |
Wider still: 17x8.5 +27 to +38; 18x8.5 +27 to +38; 19x8.5 +27 to +38; 20x8.5 +27 to +38 fit with modifications (roll fender lips, trim the plastic inner fender liner, hub-centric rings for aftermarket wheels).
In-stock PG WHEELS sets in sizes with Verified Fitment for the 2011-2013 GMC Terrain. Each card shows only the sizes that fit; prices are for a set of 4 with free shipping in the lower 48.
Modifications Required (roll fender lips, trim the plastic inner fender liner, hub-centric rings for aftermarket wheels)










The 2011-2013 GMC Terrain (Theta) uses a 5X120 bolt pattern and a 67.1 mm center bore.
Factory sizes: 17x7 +43; 17x7 +46; 18x7 +46; 19x7 +46; 19x7 +50; 19x7.5 +43; 20x7.5 +43; 20x8 +35.
Its wheel fasteners use a M14x1.5 thread.
Bolt-on sizes run from 17" to 20" in diameter; see the size table for the offset range at each width.