Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the GMC Typhoon built from 1992 to 1993.
Every 1992-1993 GMC Typhoon uses a 5X120.65 bolt pattern with a 70.3 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 70.3 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M12x1.5. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the GMC Typhoon (1st Gen) and the model years each was sold. All of them share the 5X120.65 bolt pattern.
| Submodel | Years |
|---|---|
| Base | 1992-1993 |
Wheel sizes GMC fitted to the 1992-1993 GMC Typhoon from the factory. Offsets are ET in millimeters.
| Factory size |
|---|
| 16x8 +41 front / 16x8 +13 rear |
| 17x8.5 +45 front / 17x8.5 +15 rear |
| 17x8.5 +45 front / 17x9.5 +35 rear |
Widths and offsets with Verified Fitment on the 1992-1993 GMC Typhoon: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Front offset | Rear offset |
|---|---|---|---|
| 16-18" | 8" | +24 to +46 | -4 to +19 |
| 16-18" | 8.5" | +30 to +40 | +2 to +12 |
Wider still: 16x9.5 front +22 to +33 / rear -6 to +5; 17x9.5 front +22 to +33 / rear -6 to +5; 18x9.5 front +22 to +33 / rear -6 to +5 fit with modifications (torsion-bar / front leveling for larger tires (4wd), trim front bumper valance and inner fender liner, hub-centric rings for aftermarket wheels).
The 1992-1993 GMC Typhoon (1st Gen) uses a 5X120.65 bolt pattern and a 70.3 mm center bore.
Factory sizes: 16x8 +41 front / 16x8 +13 rear; 17x8.5 +45 front / 17x8.5 +15 rear; 17x8.5 +45 front / 17x9.5 +35 rear.
Its wheel fasteners use a M12x1.5 thread.
Bolt-on sizes run from 16" to 18" in diameter; see the size table for the offset range at each width.