Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Honda Civic Type R built from 2017 to 2021 (Touring, Limited Edition).
Every 2017-2021 Honda Civic Type R uses a 5X120 bolt pattern with a 64.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 64.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M14x1.5. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Honda Civic Type R (FK8) and the model years each was sold. All of them share the 5X120 bolt pattern.
| Submodel | Years |
|---|---|
| Touring | 2017-2021 |
| Limited Edition | 2021 |
Wheel sizes Honda fitted to the 2017-2021 Honda Civic Type R from the factory. Offsets are ET in millimeters.
| Factory size |
|---|
| 20x8.5 +60 |
Widths and offsets with Verified Fitment on the 2017-2021 Honda Civic Type R: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Offset range |
|---|---|---|
| 19-20" | 8.5" | +28 to +62 |
| 19-20" | 9" | +34 to +56 |
| 19-20" | 9.5" | +41 to +50 |
Wider still: 18x10 +35 to +45; 19x10 +35 to +45; 20x10 +35 to +45 fit with modifications (roll the fender lips, add negative camber (camber bolts or arms), wheel alignment after install).
In-stock PG WHEELS sets in sizes with Verified Fitment for the 2017-2021 Honda Civic Type R. Each card shows only the sizes that fit; prices are for a set of 4 with free shipping in the lower 48.









Modifications Required (roll the fender lips, add negative camber (camber bolts or arms), wheel alignment after install)










The 2017-2021 Honda Civic Type R (FK8) uses a 5X120 bolt pattern and a 64.1 mm center bore.
Factory sizes: 20x8.5 +60.
Its wheel fasteners use a M14x1.5 thread.
Bolt-on sizes run from 19" to 20" in diameter; see the size table for the offset range at each width.