Bolt pattern, center bore, factory wheel sizes for each submodel and the aftermarket widths and offsets that bolt on to the Honda CR-Z built from 2011 to 2016 (Base, EX).
Every 2011-2016 Honda CR-Z uses a 5X114.3 bolt pattern with a 64.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 64.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M12x1.5. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Honda CR-Z (ZF1/ZF2) and the model years each was sold. All of them share the 5X114.3 bolt pattern.
| Submodel | Years | Factory wheel sizes |
|---|---|---|
| Base | 2011-2016 | See factory sizes below |
| EX | 2011-2016 | 16x6 +45 |
Wheel sizes Honda fitted to the 2011-2016 Honda CR-Z from the factory (all submodels; the table above lists them by submodel). Offsets are ET in millimeters.
| Factory size |
|---|
| 16x6 +45 |
| 17x6.5 +45 |
Widths and offsets with Verified Fitment on the 2011-2016 Honda CR-Z: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Offset range |
|---|---|---|
| 16-18" | 6" | +15 to +55 |
| 16-18" | 6.5" | +21 to +54 |
| 16-18" | 7" | +28 to +48 |
| 16-18" | 7.5" | +34 to +42 |
In-stock PG WHEELS sets in sizes with Verified Fitment for the 2011-2016 Honda CR-Z. Each card shows only the sizes that fit; prices are for a set of 4 with free shipping in the lower 48.
Modifications Required (roll rear fender lips, front camber bolts / rear camber arms for -1.5° or more, hub-centric rings for aftermarket wheels)





The 2011-2016 Honda CR-Z (ZF1/ZF2) uses a 5X114.3 bolt pattern and a 64.1 mm center bore.
Factory sizes: 16x6 +45; 17x6.5 +45.
Its wheel fasteners use a M12x1.5 thread.
Bolt-on sizes run from 16" to 18" in diameter; see the size table for the offset range at each width.