Bolt pattern, center bore, factory wheel sizes for each submodel and the aftermarket widths and offsets that bolt on to the Honda Crosstour built from 2010 to 2015 (EX, EX-L).
Every 2010-2015 Honda Crosstour uses a 5X114.3 bolt pattern with a 64.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 64.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M12x1.5. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Honda Crosstour (TF) and the model years each was sold. All of them share the 5X114.3 bolt pattern.
| Submodel | Years | Factory wheel sizes |
|---|---|---|
| EX | 2010-2015 | 17x6.5 +55 |
| EX-L | 2010-2015 | 17x6.5 +55 |
Wheel sizes Honda fitted to the 2010-2015 Honda Crosstour from the factory (all submodels; the table above lists them by submodel). Offsets are ET in millimeters.
| Factory size |
|---|
| 17x6.5 +55 |
| 18x7 +55 |
Widths and offsets with Verified Fitment on the 2010-2015 Honda Crosstour: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Offset range |
|---|---|---|
| 17-20" | 6.5" | +32 to +65 |
| 17-20" | 7" | +38 to +60 |
| 17-20" | 7.5" | +44 to +54 |
Wider still: 17x8.5 +36 to +47; 18x8.5 +36 to +47; 19x8.5 +36 to +47; 20x8.5 +36 to +47 fit with modifications (trim front bumper cover / inner fender liner at full lock, roll rear fender lips, hub-centric rings for aftermarket wheels).
In-stock PG WHEELS sets in sizes with Verified Fitment for the 2010-2015 Honda Crosstour. Each card shows only the sizes that fit; prices are for a set of 4 with free shipping in the lower 48.
Modifications Required (trim front bumper cover / inner fender liner at full lock, roll rear fender lips, hub-centric rings for aftermarket wheels)









The 2010-2015 Honda Crosstour (TF) uses a 5X114.3 bolt pattern and a 64.1 mm center bore.
Factory sizes: 17x6.5 +55; 18x7 +55.
Its wheel fasteners use a M12x1.5 thread.
Bolt-on sizes run from 17" to 20" in diameter; see the size table for the offset range at each width.