Hyundai Excel (X2) 1990-1994 Wheel Fitment Guide

Bolt pattern, center bore, factory wheel sizes for each submodel and the aftermarket widths and offsets that bolt on to the Hyundai Excel built from 1990 to 1994 (Base, GL, GLS).

Fitment specs

Bolt pattern4X114.3
Center bore67.1 mm
Lug threadM12x1.5
Model years1990-1994
GenerationX2

Every 1990-1994 Hyundai Excel uses a 4X114.3 bolt pattern with a 67.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 67.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M12x1.5. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.

Years & submodels

US-market submodels of the Hyundai Excel (X2) and the model years each was sold. All of them share the 4X114.3 bolt pattern.

SubmodelYearsFactory wheel sizes
Base1990-1994See factory sizes below
GL1990-199413x5 +40
GLS1990-199413x5 +40

Factory wheel sizes

Wheel sizes Hyundai fitted to the 1990-1994 Hyundai Excel from the factory (all submodels; the table above lists them by submodel). Offsets are ET in millimeters.

Factory size
13x5 +38
14x5.5 +35

Aftermarket sizes that bolt on

Widths and offsets with Verified Fitment on the 1990-1994 Hyundai Excel: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.

Base

DiameterWidthOffset range
13-15"5"+11 to +47
13-15"5.5"+18 to +40
13-15"6"+24 to +34

Wider still: 13x7 +16 to +27; 14x7 +16 to +27; 15x7 +16 to +27 fit with modifications (roll front and rear fender lips, front camber bolts for -1°, hub-centric rings if the wheel bore is larger).

GL, GLS

DiameterWidthOffset range
13-15"5"+11 to +47
13-15"5.5"+18 to +40
13-15"6"+24 to +34

Wider still: 13x7 +16 to +27; 14x7 +16 to +27; 15x7 +16 to +27 fit with modifications (roll front and rear fender lips, front camber bolts for -1°, hub-centric rings if the wheel bore is larger).

FAQ

What is the bolt pattern of the 1990-1994 Hyundai Excel?

The 1990-1994 Hyundai Excel (X2) uses a 4X114.3 bolt pattern and a 67.1 mm center bore.

What size wheels came on the 1990-1994 Hyundai Excel from the factory?

Factory sizes: 13x5 +38; 14x5.5 +35.

What lug thread size does the 1990-1994 Hyundai Excel use?

Its wheel fasteners use a M12x1.5 thread.

What aftermarket wheel sizes fit the 1990-1994 Hyundai Excel without modifications?

Bolt-on sizes run from 13" to 15" in diameter; see the size table for the offset range at each width.