Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Hyundai Genesis built from 2009 to 2013 (3.8, 4.6, 5.0, R-Spec).
Every 2009-2013 Hyundai Genesis uses a 5X114.3 bolt pattern with a 67.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 67.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M12x1.5. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Hyundai Genesis (BH) and the model years each was sold. All of them share the 5X114.3 bolt pattern.
| Submodel | Years |
|---|---|
| 3.8 | 2009-2013 |
| 4.6 | 2009-2011 |
| 5.0 | 2012-2013 |
| R-Spec | 2012-2013 |
Wheel sizes Hyundai fitted to the 2009-2013 Hyundai Genesis from the factory. Offsets are ET in millimeters.
| Factory size |
|---|
| 17x6.5 +31 |
| 17x7 +31 |
| 18x7.5 +33 |
| 18x7.5 +39 |
| 18x8 +33 |
| 19x8 +39 |
| 19x8 +35 front / 19x8.5 +35 rear |
| 19x8.5 +35 |
Widths and offsets with Verified Fitment on the 2009-2013 Hyundai Genesis: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Front offset | Rear offset |
|---|---|---|---|
| 17-20" | 6.5" | -1 to +41 | +3 to +41 |
| 17-20" | 7" | +5 to +47 | +9 to +47 |
| 17-20" | 7.5" | +12 to +51 | +16 to +51 |
| 17-20" | 8" | +18 to +44 | +22 to +44 |
| 17-20" | 8.5" | +24 to +38 | +28 to +38 |
| 17-20" | 9" | +31 to +32 | — |
Wider still: 17x9.5 front +16 to +31 / rear +20 to +31; 17x10 front +23 to +25 / rear —; 18x9.5 front +16 to +31 / rear +20 to +31; 18x10 front +23 to +25 / rear —; 19x9.5 front +16 to +31 / rear +20 to +31; 19x10 front +23 to +25 / rear —… fit with modifications (roll front and rear fender lips, front camber bolts / rear camber adjustment for -1° or more, hub-centric rings if the wheel bore is larger).
In-stock PG WHEELS sets in sizes with Verified Fitment for the 2009-2013 Hyundai Genesis. Each card shows only the sizes that fit; prices are for a set of 4 with free shipping in the lower 48.












Modifications Required (roll front and rear fender lips, front camber bolts / rear camber adjustment for -1° or more, hub-centric rings if the wheel bore is larger)





The 2009-2013 Hyundai Genesis (BH) uses a 5X114.3 bolt pattern and a 67.1 mm center bore.
Factory sizes: 17x6.5 +31; 17x7 +31; 18x7.5 +33; 18x7.5 +39; 18x8 +33; 19x8 +39; 19x8 +35 front / 19x8.5 +35 rear; 19x8.5 +35.
Its wheel fasteners use a M12x1.5 thread.
Bolt-on sizes run from 17" to 20" in diameter; see the size table for the offset range at each width.