Hyundai Veracruz (EN) 2007-2012 Wheel Fitment Guide

Bolt pattern, center bore, factory wheel sizes for each submodel and the aftermarket widths and offsets that bolt on to the Hyundai Veracruz built from 2007 to 2012 (GLS, SE, Limited).

Fitment specs

Bolt pattern5X114.3
Center bore67.1 mm
Lug threadM12x1.5
Model years2007-2012
GenerationEN

Every 2007-2012 Hyundai Veracruz uses a 5X114.3 bolt pattern with a 67.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 67.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M12x1.5. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.

Years & submodels

US-market submodels of the Hyundai Veracruz (EN) and the model years each was sold. All of them share the 5X114.3 bolt pattern.

SubmodelYearsFactory wheel sizes
GLS2007-201217x7 +35
SE2007-201218x7 +35
Limited2007-201218x7 +35

Factory wheel sizes

Wheel sizes Hyundai fitted to the 2007-2012 Hyundai Veracruz from the factory (all submodels; the table above lists them by submodel). Offsets are ET in millimeters.

Factory size
17x7 +35
18x7 +35
19x8 +40

Aftermarket sizes that bolt on

Widths and offsets with Verified Fitment on the 2007-2012 Hyundai Veracruz: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.

GLS

DiameterWidthOffset range
17-20"7"+18 to +41
17-20"7.5"+24 to +34

Wider still: 17x8.5 +16 to +27; 18x8.5 +16 to +27; 19x8.5 +16 to +27; 20x8.5 +16 to +27 fit with modifications (trim front bumper cover / inner fender liner at full lock, roll or pull fender lips, front camber bolts, hub-centric rings if the wheel bore is larger).

SE, Limited

DiameterWidthOffset range
18-20"7"+18 to +41
18-20"7.5"+24 to +34

Wider still: 18x8.5 +16 to +27; 19x8.5 +16 to +27; 20x8.5 +16 to +27 fit with modifications (trim front bumper cover / inner fender liner at full lock, roll or pull fender lips, front camber bolts, hub-centric rings if the wheel bore is larger).

Wheels in stock that fit

In-stock PG WHEELS sets in sizes with Verified Fitment for the 2007-2012 Hyundai Veracruz. Each card shows only the sizes that fit; prices are for a set of 4 with free shipping in the lower 48.

Modifications Required (trim front bumper cover / inner fender liner at full lock, roll or pull fender lips, front camber bolts, hub-centric rings if the wheel bore is larger)

FAQ

What is the bolt pattern of the 2007-2012 Hyundai Veracruz?

The 2007-2012 Hyundai Veracruz (EN) uses a 5X114.3 bolt pattern and a 67.1 mm center bore.

What size wheels came on the 2007-2012 Hyundai Veracruz from the factory?

Factory sizes: 17x7 +35; 18x7 +35; 19x8 +40.

What lug thread size does the 2007-2012 Hyundai Veracruz use?

Its wheel fasteners use a M12x1.5 thread.

What aftermarket wheel sizes fit the 2007-2012 Hyundai Veracruz without modifications?

Bolt-on sizes run from 17" to 20" in diameter; see the size table for the offset range at each width.