Bolt pattern, center bore, factory wheel sizes for each submodel and the aftermarket widths and offsets that bolt on to the Infiniti FX37 built from 2013 to 2013.
Every 2013 Infiniti FX37 uses a 5X114.3 bolt pattern with a 66.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 66.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Infiniti FX37 (S51) and the model years each was sold. All of them share the 5X114.3 bolt pattern.
| Submodel | Years | Factory wheel sizes |
|---|---|---|
| Base | 2013 | 18x8 +50 |
Wheel sizes Infiniti fitted to the 2013 Infiniti FX37 from the factory (all submodels; the table above lists them by submodel). Offsets are ET in millimeters.
| Factory size |
|---|
| 18x8 +50 |
| 19x8 +50 |
| 20x8 +50 |
| 21x9.5 +50 |
| 22x10 +45 |
Widths and offsets with Verified Fitment on the 2013 Infiniti FX37: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Offset range |
|---|---|---|
| 18-22" | 8" | +33 to +55 |
| 18-22" | 8.5" | +39 to +49 |
Wider still: 18x9.5 +31 to +42; 19x9.5 +31 to +42; 20x9.5 +31 to +42; 21x9.5 +31 to +42; 22x9.5 +31 to +42 fit with modifications (roll fender lips, trim plastic fender liners / bumper edges, camber bolts for wider, lower-offset wheels).
In-stock PG WHEELS sets in sizes with Verified Fitment for the 2013 Infiniti FX37. Each card shows only the sizes that fit; prices are for a set of 4 with free shipping in the lower 48.






Modifications Required (roll fender lips, trim plastic fender liners / bumper edges, camber bolts for wider, lower-offset wheels)












The 2013 Infiniti FX37 (S51) uses a 5X114.3 bolt pattern and a 66.1 mm center bore.
Factory sizes: 18x8 +50; 19x8 +50; 20x8 +50; 21x9.5 +50; 22x10 +45.
Bolt-on sizes run from 18" to 22" in diameter; see the size table for the offset range at each width.