Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Infiniti G25 built from 2011 to 2012 (Base, Journey, G25x).
Every 2011-2012 Infiniti G25 uses a 5X114.3 bolt pattern with a 66.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 66.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Infiniti G25 (V36) and the model years each was sold. All of them share the 5X114.3 bolt pattern.
| Submodel | Years |
|---|---|
| Base | 2011-2012 |
| Journey | 2011-2012 |
| G25x | 2011-2012 |
Wheel sizes Infiniti fitted to the 2011-2012 Infiniti G25 from the factory. Offsets are ET in millimeters.
| Factory size |
|---|
| 17x7.5 +45 |
| 18x7.5 +45 |
| 18x7.5 +45 front / 18x8.5 +50 rear |
| 19x7.5 +45 front / 19x8.5 +50 rear |
Widths and offsets with Verified Fitment on the 2011-2012 Infiniti G25: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Front offset | Rear offset |
|---|---|---|---|
| 18-19" | 7.5" | +28 to +50 | — |
| 18-19" | 8" | +34 to +44 | — |
| 18-19" | 8.5" | — | +33 to +55 |
| 18-19" | 9" | — | +39 to +49 |
Wider still: 18x10 front — / rear +31 to +42; 19x10 front — / rear +31 to +42 fit with modifications (roll or pull rear fender lips, rear camber arms for -1.5° or more, front camber bolts / arms, trim inner liner if needed).
In-stock PG WHEELS sets in sizes with Verified Fitment for the 2011-2012 Infiniti G25. Each card shows only the sizes that fit; prices are for a set of 4 with free shipping in the lower 48.
Modifications Required (roll or pull rear fender lips, rear camber arms for -1.5° or more, front camber bolts / arms, trim inner liner if needed)












The 2011-2012 Infiniti G25 (V36) uses a 5X114.3 bolt pattern and a 66.1 mm center bore.
Factory sizes: 17x7.5 +45; 18x7.5 +45; 18x7.5 +45 front / 18x8.5 +50 rear; 19x7.5 +45 front / 19x8.5 +50 rear.
Bolt-on sizes run from 18" to 19" in diameter; see the size table for the offset range at each width.