Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Infiniti I35 built from 2002 to 2004.
Every 2002-2004 Infiniti I35 uses a 5X114.3 bolt pattern with a 66.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 66.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Infiniti I35 (A33) and the model years each was sold. All of them share the 5X114.3 bolt pattern.
| Submodel | Years |
|---|---|
| Base | 2002-2004 |
Wheel sizes Infiniti fitted to the 2002-2004 Infiniti I35 from the factory. Offsets are ET in millimeters.
| Factory size |
|---|
| 17x7 +40 |
| 17x7.5 +43 |
| 18x8 +38 |
| 19x8 +38 |
| 20x9 +33 |
Widths and offsets with Verified Fitment on the 2002-2004 Infiniti I35: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Offset range |
|---|---|---|
| 16-18" | 7" | +23 to +45 |
| 16-18" | 7.5" | +29 to +39 |
Wider still: 16x8.5 +21 to +32; 17x8.5 +21 to +32; 18x8.5 +21 to +32 fit with modifications (roll front and rear fender lips, front camber bolts (strut) for -1° or more, hub-centric rings if the wheel bore is larger).
In-stock PG WHEELS sets in sizes with Verified Fitment for the 2002-2004 Infiniti I35. Each card shows only the sizes that fit; prices are for a set of 4 with free shipping in the lower 48.
Modifications Required (roll front and rear fender lips, front camber bolts (strut) for -1° or more, hub-centric rings if the wheel bore is larger)







The 2002-2004 Infiniti I35 (A33) uses a 5X114.3 bolt pattern and a 66.1 mm center bore.
Factory sizes: 17x7 +40; 17x7.5 +43; 18x8 +38; 19x8 +38; 20x9 +33.
Bolt-on sizes run from 16" to 18" in diameter; see the size table for the offset range at each width.