Bolt pattern, center bore, factory wheel sizes for each submodel and the aftermarket widths and offsets that bolt on to the Infiniti M built from 2011 to 2013 (M37, M56, M35h).
Every 2011-2013 Infiniti M uses a 5X114.3 bolt pattern with a 66.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 66.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M12x1.25. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Infiniti M (Y51) and the model years each was sold. All of them share the 5X114.3 bolt pattern.
| Submodel | Years | Factory wheel sizes |
|---|---|---|
| M37 | 2011-2013 | See factory sizes below |
| M56 | 2011-2013 | See factory sizes below |
| M35h | 2012-2013 | 19x8.5 +47 19x9.5 +39 |
Wheel sizes Infiniti fitted to the 2011-2013 Infiniti M from the factory (all submodels; the table above lists them by submodel). Offsets are ET in millimeters.
| Factory size |
|---|
| 19x8.5 +47 |
| 19x9.5 +39 |
| 20x9 +43 |
| 20x9.5 +39 |
| 20x10 +45 |
| 21x10 +45 |
Widths and offsets with Verified Fitment on the 2011-2013 Infiniti M: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Offset range |
|---|---|---|
| 19-21" | 8.5" | +20 to +55 |
| 19-21" | 9" | +26 to +48 |
| 19-21" | 9.5" | +32 to +42 |
Wider still: 19x10.5 +24 to +35; 20x10.5 +24 to +35; 21x10.5 +24 to +35 fit with modifications (roll or pull rear fender lips, rear camber arms for -1.5° or more, front camber bolts / arms, trim inner liner if needed).
In-stock PG WHEELS sets in sizes with Verified Fitment for the 2011-2013 Infiniti M. Each card shows only the sizes that fit; prices are for a set of 4 with free shipping in the lower 48.












Modifications Required (roll or pull rear fender lips, rear camber arms for -1.5° or more, front camber bolts / arms, trim inner liner if needed)
The 2011-2013 Infiniti M (Y51) uses a 5X114.3 bolt pattern and a 66.1 mm center bore.
Factory sizes: 19x8.5 +47; 19x9.5 +39; 20x9 +43; 20x9.5 +39; 20x10 +45; 21x10 +45.
Its wheel fasteners use a M12x1.25 thread.
Bolt-on sizes run from 19" to 21" in diameter; see the size table for the offset range at each width.