Infiniti M30 (F31) 1990-1992 Wheel Fitment Guide

Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Infiniti M30 built from 1990 to 1992 (Coupe, Convertible).

Fitment specs

Bolt pattern5X114.3
Center bore66.1 mm
Model years1990-1992
GenerationF31

Every 1990-1992 Infiniti M30 uses a 5X114.3 bolt pattern with a 66.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 66.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.

Years & submodels

US-market submodels of the Infiniti M30 (F31) and the model years each was sold. All of them share the 5X114.3 bolt pattern.

SubmodelYears
Coupe1990-1992
Convertible1991-1992

Factory wheel sizes

Wheel sizes Infiniti fitted to the 1990-1992 Infiniti M30 from the factory. Offsets are ET in millimeters.

Factory size
15x6.5 +33

Aftermarket sizes that bolt on

Widths and offsets with Verified Fitment on the 1990-1992 Infiniti M30: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.

DiameterWidthOffset range
15-18"6.5"+16 to +38
15-18"7"+22 to +32

Wider still: 15x8 +14 to +25; 16x8 +14 to +25; 17x8 +14 to +25; 18x8 +14 to +25 fit with modifications (roll or pull rear fender lips, rear camber arms for -1.5° or more, front camber bolts / arms, trim inner liner if needed).

FAQ

What is the bolt pattern of the 1990-1992 Infiniti M30?

The 1990-1992 Infiniti M30 (F31) uses a 5X114.3 bolt pattern and a 66.1 mm center bore.

What size wheels came on the 1990-1992 Infiniti M30 from the factory?

Factory sizes: 15x6.5 +33.

What aftermarket wheel sizes fit the 1990-1992 Infiniti M30 without modifications?

Bolt-on sizes run from 15" to 18" in diameter; see the size table for the offset range at each width.