Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Infiniti M45 built from 2003 to 2004 (Base, With TPMS).
Every 2003-2004 Infiniti M45 uses a 5X114.3 bolt pattern with a 66.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 66.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Infiniti M45 (Y34) and the model years each was sold. All of them share the 5X114.3 bolt pattern.
| Submodel | Years |
|---|---|
| Base | 2003-2004 |
| With TPMS | 2003-2004 |
Wheel sizes Infiniti fitted to the 2003-2004 Infiniti M45 from the factory. Offsets are ET in millimeters.
| Factory size |
|---|
| 18x7.5 +40 |
| 18x8 +43 |
| 19x7.5 +40 |
| 19x8.5 +39 |
| 20x9 +35 |
Widths and offsets with Verified Fitment on the 2003-2004 Infiniti M45: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Offset range |
|---|---|---|
| 18-19" | 7.5" | +23 to +45 |
| 18-19" | 8" | +29 to +39 |
Wider still: 18x9 +21 to +32; 19x9 +21 to +32 fit with modifications (roll or pull rear fender lips, rear camber arms for -1.5° or more, front camber bolts / arms, trim inner liner if needed).
In-stock PG WHEELS sets in sizes with Verified Fitment for the 2003-2004 Infiniti M45. Each card shows only the sizes that fit; prices are for a set of 4 with free shipping in the lower 48.






Modifications Required (roll or pull rear fender lips, rear camber arms for -1.5° or more, front camber bolts / arms, trim inner liner if needed)












The 2003-2004 Infiniti M45 (Y34) uses a 5X114.3 bolt pattern and a 66.1 mm center bore.
Factory sizes: 18x7.5 +40; 18x8 +43; 19x7.5 +40; 19x8.5 +39; 20x9 +35.
Bolt-on sizes run from 18" to 19" in diameter; see the size table for the offset range at each width.