Bolt pattern, center bore, factory wheel sizes for each submodel and the aftermarket widths and offsets that bolt on to the Infiniti QX50 built from 2014 to 2017.
Every 2014-2017 Infiniti QX50 uses a 5X114.3 bolt pattern with a 66.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 66.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M12x1.25. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Infiniti QX50 (J50) and the model years each was sold. All of them share the 5X114.3 bolt pattern.
| Submodel | Years | Factory wheel sizes |
|---|---|---|
| Base | 2014-2017 | 18x8 +47 19x8 +47 19x8.5 +50 20x9 +45 21x10 +35 |
Wheel sizes Infiniti fitted to the 2014-2017 Infiniti QX50 from the factory (all submodels; the table above lists them by submodel). Offsets are ET in millimeters.
| Factory size |
|---|
| 18x8 +47 |
| 19x8 +47 |
| 19x8.5 +50 |
| 20x9 +45 |
| 21x10 +35 |
Widths and offsets with Verified Fitment on the 2014-2017 Infiniti QX50: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Offset range |
|---|---|---|
| 18-21" | 8" | +34 to +47 |
Wider still: 18x9 +26 to +37; 19x9 +26 to +37; 20x9 +26 to +37; 21x9 +26 to +37 fit with modifications (roll or pull rear fender lips, rear camber arms for -1.5° or more, front camber bolts / arms, trim inner liner if needed).
In-stock PG WHEELS sets in sizes with Verified Fitment for the 2014-2017 Infiniti QX50. Each card shows only the sizes that fit; prices are for a set of 4 with free shipping in the lower 48.






Modifications Required (roll or pull rear fender lips, rear camber arms for -1.5° or more, front camber bolts / arms, trim inner liner if needed)












The 2014-2017 Infiniti QX50 (J50) uses a 5X114.3 bolt pattern and a 66.1 mm center bore.
Factory sizes: 18x8 +47; 19x8 +47; 19x8.5 +50; 20x9 +45; 21x10 +35.
Its wheel fasteners use a M12x1.25 thread.
Bolt-on sizes run from 18" to 21" in diameter; see the size table for the offset range at each width.