Bolt pattern, center bore, factory wheel sizes for each submodel and the aftermarket widths and offsets that bolt on to the Infiniti QX56 built from 2011 to 2013.
Every 2011-2013 Infiniti QX56 uses a 6X139.7 bolt pattern with a 77.8 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 77.8 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M14x1.5. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Infiniti QX56 (Z62) and the model years each was sold. All of them share the 6X139.7 bolt pattern.
| Submodel | Years | Factory wheel sizes |
|---|---|---|
| Base | 2011-2013 | 20x8 +30 22x8 +30 22x10 +20 |
Wheel sizes Infiniti fitted to the 2011-2013 Infiniti QX56 from the factory (all submodels; the table above lists them by submodel). Offsets are ET in millimeters.
| Factory size |
|---|
| 20x8 +30 |
| 22x8 +30 |
| 22x10 +20 |
Widths and offsets with Verified Fitment on the 2011-2013 Infiniti QX56: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Offset range |
|---|---|---|
| 20-22" | 8" | +13 to +35 |
| 20-22" | 8.5" | +19 to +29 |
Wider still: 20x9.5 +11 to +22; 21x9.5 +11 to +22; 22x9.5 +11 to +22 fit with modifications (2-in leveling kit for 32-33 in tires, trim front bumper / air dam and inner fender liners, aftermarket upper control arms if leveled more than 2 in).
In-stock PG WHEELS sets in sizes with Verified Fitment for the 2011-2013 Infiniti QX56. Each card shows only the sizes that fit; prices are for a set of 4 with free shipping in the lower 48.
Modifications Required (2-in leveling kit for 32-33 in tires, trim front bumper / air dam and inner fender liners, aftermarket upper control arms if leveled more than 2 in)







The 2011-2013 Infiniti QX56 (Z62) uses a 6X139.7 bolt pattern and a 77.8 mm center bore.
Factory sizes: 20x8 +30; 22x8 +30; 22x10 +20.
Its wheel fasteners use a M14x1.5 thread.
Bolt-on sizes run from 20" to 22" in diameter; see the size table for the offset range at each width.