Jeep Commander (XK) 2006-2010 Wheel Fitment Guide

Bolt pattern, center bore, factory wheel sizes for each submodel and the aftermarket widths and offsets that bolt on to the Jeep Commander built from 2006 to 2010 (Sport, Limited, Overland).

Fitment specs

Bolt pattern5X127
Center bore71.5 mm
Lug thread1/2"-20UNF
Model years2006-2010
GenerationXK

Every 2006-2010 Jeep Commander uses a 5X127 bolt pattern with a 71.5 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 71.5 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is 1/2"-20UNF. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.

Years & submodels

US-market submodels of the Jeep Commander (XK) and the model years each was sold. All of them share the 5X127 bolt pattern.

SubmodelYearsFactory wheel sizes
Sport2006-201017x7.5 +44
Limited2006-201017x7.5 +44
Overland2007-201017x7.5 +44
18x7.5 +44

Factory wheel sizes

Wheel sizes Jeep fitted to the 2006-2010 Jeep Commander from the factory (all submodels; the table above lists them by submodel). Offsets are ET in millimeters.

Factory size
17x7.5 +44
18x7.5 +44
19x7.5 +44
19x8 +45

Aftermarket sizes that bolt on

Widths and offsets with Verified Fitment on the 2006-2010 Jeep Commander: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.

DiameterWidthOffset range
17-21"7.5"+27 to +49
17-21"8"+33 to +43

Wider still: 17x9 +25 to +36; 18x9 +25 to +36; 19x9 +25 to +36; 20x9 +25 to +36; 21x9 +25 to +36 fit with modifications (roll fender lips / trim plastic fender liners, 1-2 in leveling or lift kit for larger tires, hub-centric rings for aftermarket wheels).

FAQ

What is the bolt pattern of the 2006-2010 Jeep Commander?

The 2006-2010 Jeep Commander (XK) uses a 5X127 bolt pattern and a 71.5 mm center bore.

What size wheels came on the 2006-2010 Jeep Commander from the factory?

Factory sizes: 17x7.5 +44; 18x7.5 +44; 19x7.5 +44; 19x8 +45.

What lug thread size does the 2006-2010 Jeep Commander use?

Its wheel fasteners use a 1/2"-20UNF thread.

What aftermarket wheel sizes fit the 2006-2010 Jeep Commander without modifications?

Bolt-on sizes run from 17" to 21" in diameter; see the size table for the offset range at each width.