Jeep Grand Cherokee (ZJ) 1993-1998 Wheel Fitment Guide

Bolt pattern, center bore, factory wheel sizes for each submodel and the aftermarket widths and offsets that bolt on to the Jeep Grand Cherokee built from 1993 to 1998 (Base, Laredo, TSi, Limited, 5.9 Limited).

Fitment specs

Bolt pattern5X114.3
Center bore71.5 mm
Lug thread1/2"-20UNF
Model years1993-1998
GenerationZJ

Every 1993-1998 Jeep Grand Cherokee uses a 5X114.3 bolt pattern with a 71.5 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 71.5 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is 1/2"-20UNF. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.

Years & submodels

US-market submodels of the Jeep Grand Cherokee (ZJ) and the model years each was sold. All of them share the 5X114.3 bolt pattern.

SubmodelYearsFactory wheel sizes
Base1993See factory sizes below
Laredo1993-199815x7 +25
15x7 +25.4
15x7 +32
15x7.5 +25
TSi1997-199815x7 +25
15x7 +25.4
15x7 +32
15x7.5 +25
Limited1993-199815x7 +25
15x7 +25.4
15x7 +32
15x7.5 +25
16x7 +31
16x7.5 +25
16x8 +31
5.9 Limited1998See factory sizes below

Factory wheel sizes

Wheel sizes Jeep fitted to the 1993-1998 Jeep Grand Cherokee from the factory (all submodels; the table above lists them by submodel). Offsets are ET in millimeters.

Factory size
15x7 +25
15x7 +32
15x7.5 +25
16x7 +31
16x7.5 +25
16x8 +31
17x7.5 +31
18x8 +25

Aftermarket sizes that bolt on

Widths and offsets with Verified Fitment on the 1993-1998 Jeep Grand Cherokee: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.

Base, 5.9 Limited

DiameterWidthOffset range
15-20"7"+15 to +38
15-20"7.5"+21 to +31

Wider still: 15x8.5 +13 to +24; 16x8.5 +13 to +24; 17x8.5 +13 to +24; 18x8.5 +13 to +24; 19x8.5 +13 to +24; 20x8.5 +13 to +24 fit with modifications (2-3 in lift kit for 30-31 in tires, trim front bumper end caps / fender flares, hub-centric rings or lug-centric wheels with correct seat).

Laredo, TSi, Limited

DiameterWidthOffset range
15-20"7"+15 to +35
15-20"7.5"+21 to +31

Wider still: 15x8.5 +13 to +24; 16x8.5 +13 to +24; 17x8.5 +13 to +24; 18x8.5 +13 to +24; 19x8.5 +13 to +24; 20x8.5 +13 to +24 fit with modifications (2-3 in lift kit for 30-31 in tires, trim front bumper end caps / fender flares, hub-centric rings or lug-centric wheels with correct seat).

Wheels in stock that fit

In-stock PG WHEELS sets in sizes with Verified Fitment for the 1993-1998 Jeep Grand Cherokee. Each card shows only the sizes that fit; prices are for a set of 4 with free shipping in the lower 48.

Base, 5.9 Limited

Modifications Required (2-3 in lift kit for 30-31 in tires, trim front bumper end caps / fender flares, hub-centric rings or lug-centric wheels with correct seat)

Laredo, TSi, Limited

Modifications Required (2-3 in lift kit for 30-31 in tires, trim front bumper end caps / fender flares, hub-centric rings or lug-centric wheels with correct seat)

FAQ

What is the bolt pattern of the 1993-1998 Jeep Grand Cherokee?

The 1993-1998 Jeep Grand Cherokee (ZJ) uses a 5X114.3 bolt pattern and a 71.5 mm center bore.

What size wheels came on the 1993-1998 Jeep Grand Cherokee from the factory?

Factory sizes: 15x7 +25; 15x7 +32; 15x7.5 +25; 16x7 +31; 16x7.5 +25; 16x8 +31; 17x7.5 +31; 18x8 +25.

What lug thread size does the 1993-1998 Jeep Grand Cherokee use?

Its wheel fasteners use a 1/2"-20UNF thread.

What aftermarket wheel sizes fit the 1993-1998 Jeep Grand Cherokee without modifications?

Bolt-on sizes run from 15" to 20" in diameter; see the size table for the offset range at each width.