Mazda 626 (GE) 1993-1997 Wheel Fitment Guide

Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Mazda 626 built from 1993 to 1997 (DX, ES, LX).

Fitment specs

Bolt pattern5X114.3
Center bore67.1 mm
Lug threadM12x1.5
Model years1993-1997
GenerationGE

Every 1993-1997 Mazda 626 uses a 5X114.3 bolt pattern with a 67.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 67.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M12x1.5. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.

Years & submodels

US-market submodels of the Mazda 626 (GE) and the model years each was sold. All of them share the 5X114.3 bolt pattern.

SubmodelYears
DX1993-1997
ES1993-1997
LX1993-1997

Factory wheel sizes

Wheel sizes Mazda fitted to the 1993-1997 Mazda 626 from the factory. Offsets are ET in millimeters.

Factory size
14x5.5 +45
15x6 +50
15x6.5 +48
16x7 +42

Aftermarket sizes that bolt on

Widths and offsets with Verified Fitment on the 1993-1997 Mazda 626: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.

DiameterWidthOffset range
14-18"5.5"+27 to +55
14-18"6"+33 to +55
14-18"6.5"+39 to +49

Wider still: 14x7.5 +31 to +42; 15x7.5 +31 to +42; 16x7.5 +31 to +42; 17x7.5 +31 to +42; 18x7.5 +31 to +42 fit with modifications (roll front and rear fender lips, front camber bolts / rear camber adjustment for -1° or more, hub-centric rings if the wheel bore is larger).

Wheels in stock that fit

In-stock PG WHEELS sets in sizes with Verified Fitment for the 1993-1997 Mazda 626. Each card shows only the sizes that fit; prices are for a set of 4 with free shipping in the lower 48.

Modifications Required (roll front and rear fender lips, front camber bolts / rear camber adjustment for -1° or more, hub-centric rings if the wheel bore is larger)

FAQ

What is the bolt pattern of the 1993-1997 Mazda 626?

The 1993-1997 Mazda 626 (GE) uses a 5X114.3 bolt pattern and a 67.1 mm center bore.

What size wheels came on the 1993-1997 Mazda 626 from the factory?

Factory sizes: 14x5.5 +45; 15x6 +50; 15x6.5 +48; 16x7 +42.

What lug thread size does the 1993-1997 Mazda 626 use?

Its wheel fasteners use a M12x1.5 thread.

What aftermarket wheel sizes fit the 1993-1997 Mazda 626 without modifications?

Bolt-on sizes run from 14" to 18" in diameter; see the size table for the offset range at each width.