Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Mazda 929 built from 1992 to 1995 (Base, S).
Every 1992-1995 Mazda 929 uses a 5X114.3 bolt pattern with a 67.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 67.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M12x1.5. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Mazda 929 (HD) and the model years each was sold. All of them share the 5X114.3 bolt pattern.
| Submodel | Years |
|---|---|
| Base | 1992-1995 |
| S | 1992-1995 |
Wheel sizes Mazda fitted to the 1992-1995 Mazda 929 from the factory. Offsets are ET in millimeters.
| Factory size |
|---|
| 15x6.5 +55 |
| 16x7 +50 |
Widths and offsets with Verified Fitment on the 1992-1995 Mazda 929: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Offset range |
|---|---|---|
| 15-17" | 6.5" | +38 to +60 |
| 15-17" | 7" | +44 to +54 |
Wider still: 15x8 +36 to +47; 16x8 +36 to +47; 17x8 +36 to +47 fit with modifications (roll front and rear fender lips, front camber bolts for -1°, hub-centric rings if the wheel bore is larger).
In-stock PG WHEELS sets in sizes with Verified Fitment for the 1992-1995 Mazda 929. Each card shows only the sizes that fit; prices are for a set of 4 with free shipping in the lower 48.
Modifications Required (roll front and rear fender lips, front camber bolts for -1°, hub-centric rings if the wheel bore is larger)
The 1992-1995 Mazda 929 (HD) uses a 5X114.3 bolt pattern and a 67.1 mm center bore.
Factory sizes: 15x6.5 +55; 16x7 +50.
Its wheel fasteners use a M12x1.5 thread.
Bolt-on sizes run from 15" to 17" in diameter; see the size table for the offset range at each width.