Bolt pattern, center bore, factory wheel sizes for each submodel and the aftermarket widths and offsets that bolt on to the Mazda MX-3 built from 1992 to 1995 (Base, GS).
Every 1992-1995 Mazda MX-3 uses a 4X100 bolt pattern with a 54.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 54.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M12x1.5. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Mazda MX-3 (EC) and the model years each was sold. All of them share the 4X100 bolt pattern.
| Submodel | Years | Factory wheel sizes |
|---|---|---|
| Base | 1992-1995 | See factory sizes below |
| GS | 1992-1995 | 15x6 +45 |
Wheel sizes Mazda fitted to the 1992-1995 Mazda MX-3 from the factory (all submodels; the table above lists them by submodel). Offsets are ET in millimeters.
| Factory size |
|---|
| 14x5.5 +45 |
| 15x6 +45 |
| 15x6 +48 |
| 16x7 +42 |
Widths and offsets with Verified Fitment on the 1992-1995 Mazda MX-3: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Offset range |
|---|---|---|
| 14-17" | 5.5" | +28 to +50 |
| 14-17" | 6" | +34 to +44 |
Wider still: 14x7 +26 to +37; 15x7 +26 to +37; 16x7 +26 to +37; 17x7 +26 to +37 fit with modifications (roll front and rear fender lips, front camber bolts for -1°, hub-centric rings if the wheel bore is larger).
| Diameter | Width | Offset range |
|---|---|---|
| 15-17" | 6" | +34 to +45 |
Wider still: 15x7 +26 to +37; 16x7 +26 to +37; 17x7 +26 to +37 fit with modifications (roll front and rear fender lips, front camber bolts for -1°, hub-centric rings if the wheel bore is larger).
The 1992-1995 Mazda MX-3 (EC) uses a 4X100 bolt pattern and a 54.1 mm center bore.
Factory sizes: 14x5.5 +45; 15x6 +45; 15x6 +48; 16x7 +42.
Its wheel fasteners use a M12x1.5 thread.
Bolt-on sizes run from 14" to 17" in diameter; see the size table for the offset range at each width.