Bolt pattern, center bore, factory wheel sizes for each submodel and the aftermarket widths and offsets that bolt on to the Mitsubishi Lancer built from 2002 to 2007 (ES, LS, O-Z Rally, Ralliart).
Every 2002-2007 Mitsubishi Lancer uses a 4X100 bolt pattern with a 56.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 56.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M12x1.5. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Mitsubishi Lancer (CS) and the model years each was sold. All of them share the 4X100 bolt pattern.
| Submodel | Years | Factory wheel sizes |
|---|---|---|
| ES | 2002-2007 | 14x5.5 +46 |
| LS | 2002-2007 | 15x6 +46 |
| O-Z Rally | 2002-2007 | 15x6 +46 |
| Ralliart | 2004-2006 | See factory sizes below |
Wheel sizes Mitsubishi fitted to the 2002-2007 Mitsubishi Lancer from the factory (all submodels; the table above lists them by submodel). Offsets are ET in millimeters.
| Factory size |
|---|
| 14x5.5 +46 |
| 15x6 +46 |
| 16x6 +46 |
Widths and offsets with Verified Fitment on the 2002-2007 Mitsubishi Lancer: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Offset range |
|---|---|---|
| 14-15" | 5.5" | +29 to +51 |
| 14-15" | 6" | +35 to +45 |
Wider still: 14x7 +27 to +38; 15x7 +27 to +38 fit with modifications (roll front and rear fender lips, front camber bolts for -1°, hub-centric rings if the wheel bore is larger).
| Diameter | Width | Offset range |
|---|---|---|
| 15" | 6" | +35 to +46 |
Wider still: 15x7 +27 to +38 fit with modifications (roll front and rear fender lips, front camber bolts for -1°, hub-centric rings if the wheel bore is larger).
The 2002-2007 Mitsubishi Lancer (CS) uses a 4X100 bolt pattern and a 56.1 mm center bore.
Factory sizes: 14x5.5 +46; 15x6 +46; 16x6 +46.
Its wheel fasteners use a M12x1.5 thread.
Bolt-on sizes run from 14" to 15" in diameter; see the size table for the offset range at each width.