Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Mitsubishi Lancer Evolution X built from 2008 to 2015 (GSR, MR, Final Edition).
Every 2008-2015 Mitsubishi Lancer Evolution X uses a 5X114.3 bolt pattern with a 67.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 67.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M12x1.5. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Mitsubishi Lancer Evolution X (CZ4A) and the model years each was sold. All of them share the 5X114.3 bolt pattern.
| Submodel | Years |
|---|---|
| GSR | 2008-2015 |
| MR | 2008-2015 |
| Final Edition | 2015 |
Wheel sizes Mitsubishi fitted to the 2008-2015 Mitsubishi Lancer Evolution X from the factory. Offsets are ET in millimeters.
| Factory size |
|---|
| 18x8.5 +38 |
Widths and offsets with Verified Fitment on the 2008-2015 Mitsubishi Lancer Evolution X: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Offset range |
|---|---|---|
| 18-19" | 8.5" | +21 to +43 |
| 18-19" | 9" | +27 to +37 |
Wider still: 18x10 +19 to +30; 19x10 +19 to +30 fit with modifications (roll and lightly pull rear fender lips, front camber bolts / rear camber arms for -1.5° or more, check strut and caliper clearance on low-offset wheels).
In-stock PG WHEELS sets in sizes with Verified Fitment for the 2008-2015 Mitsubishi Lancer Evolution X. Each card shows only the sizes that fit; prices are for a set of 4 with free shipping in the lower 48.












Modifications Required (roll and lightly pull rear fender lips, front camber bolts / rear camber arms for -1.5° or more, check strut and caliper clearance on low-offset wheels)








The 2008-2015 Mitsubishi Lancer Evolution X (CZ4A) uses a 5X114.3 bolt pattern and a 67.1 mm center bore.
Factory sizes: 18x8.5 +38.
Its wheel fasteners use a M12x1.5 thread.
Bolt-on sizes run from 18" to 19" in diameter; see the size table for the offset range at each width.