Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Nissan Axxess built from 1990 to 1990 (XE, SE).
Every 1990 Nissan Axxess uses a 4X114.3 bolt pattern with a 66.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 66.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Nissan Axxess (M11) and the model years each was sold. All of them share the 4X114.3 bolt pattern.
| Submodel | Years |
|---|---|
| XE | 1990 |
| SE | 1990 |
Wheel sizes Nissan fitted to the 1990 Nissan Axxess from the factory. Offsets are ET in millimeters.
| Factory size |
|---|
| 14x5.5 +32 |
Widths and offsets with Verified Fitment on the 1990 Nissan Axxess: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Offset range |
|---|---|---|
| 14-15" | 5.5" | +15 to +37 |
| 14-15" | 6" | +21 to +31 |
Wider still: 14x7 +13 to +24; 15x7 +13 to +24 fit with modifications (roll fender lips, trim plastic fender liners, hub-centric rings if the wheel bore is larger).
The 1990 Nissan Axxess (M11) uses a 4X114.3 bolt pattern and a 66.1 mm center bore.
Factory sizes: 14x5.5 +32.
Bolt-on sizes run from 14" to 15" in diameter; see the size table for the offset range at each width.