Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Nissan Hardbody built from 1986 to 1997 (Base, XE, SE).
Every 1986-1997 Nissan Hardbody uses a 6X139.7 bolt pattern with a 100.3 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 100.3 mm inner diameter so the wheel centers on the hub instead of the lugs. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Nissan Hardbody (D21) and the model years each was sold. All of them share the 6X139.7 bolt pattern.
| Submodel | Years |
|---|---|
| Base | 1986-1997 |
| XE | 1986-1997 |
| SE | 1986-1997 |
Wheel sizes Nissan fitted to the 1986-1997 Nissan Hardbody from the factory. Offsets are ET in millimeters.
| Factory size |
|---|
| 14x6 +30 |
| 15x7.5 +12 |
Widths and offsets with Verified Fitment on the 1986-1997 Nissan Hardbody: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Offset range |
|---|---|---|
| 14-17" | 6" | -24 to +37 |
| 14-17" | 6.5" | -18 to +30 |
| 14-17" | 7" | -12 to +24 |
| 14-17" | 7.5" | -5 to +17 |
| 14-17" | 8" | +1 to +11 |
Wider still: 14x9 -7 to +4; 15x9 -7 to +4; 16x9 -7 to +4; 17x9 -7 to +4 fit with modifications (2-in leveling kit for 32-33 in tires, trim front bumper / air dam and inner fender liners, aftermarket upper control arms if leveled more than 2 in).
The 1986-1997 Nissan Hardbody (D21) uses a 6X139.7 bolt pattern and a 100.3 mm center bore.
Factory sizes: 14x6 +30; 15x7.5 +12.
Bolt-on sizes run from 14" to 17" in diameter; see the size table for the offset range at each width.