Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Nissan Leaf built from 2026 to 2026 (Platinum+, S+, SV+).
Every 2026 Nissan Leaf uses a 5X114.3 bolt pattern with a 66.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 66.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M12x1.25. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Nissan Leaf (ZE2) and the model years each was sold. All of them share the 5X114.3 bolt pattern.
| Submodel | Years |
|---|---|
| Platinum+ | 2026 |
| S+ | 2026 |
| SV+ | 2026 |
Wheel sizes Nissan fitted to the 2026 Nissan Leaf from the factory. Offsets are ET in millimeters.
| Factory size |
|---|
| 18x6.5 +45 |
| 18x7 +50 |
| 19x7.5 +50 |
Widths and offsets with Verified Fitment on the 2026 Nissan Leaf: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Offset range |
|---|---|---|
| 18-21" | 6.5" | +20 to +55 |
| 18-21" | 7" | +26 to +61 |
| 18-21" | 7.5" | +33 to +55 |
| 18-21" | 8" | +39 to +49 |
Wider still: 18x9 +31 to +42; 19x9 +31 to +42; 20x9 +31 to +42; 21x9 +31 to +42 fit with modifications (roll fender lips, trim plastic fender liners / bumper edges, camber bolts for wider, lower-offset wheels).
In-stock PG WHEELS sets in sizes with Verified Fitment for the 2026 Nissan Leaf. Each card shows only the sizes that fit; prices are for a set of 4 with free shipping in the lower 48.
Modifications Required (roll fender lips, trim plastic fender liners / bumper edges, camber bolts for wider, lower-offset wheels)












The 2026 Nissan Leaf (ZE2) uses a 5X114.3 bolt pattern and a 66.1 mm center bore.
Factory sizes: 18x6.5 +45; 18x7 +50; 19x7.5 +50.
Its wheel fasteners use a M12x1.25 thread.
Bolt-on sizes run from 18" to 21" in diameter; see the size table for the offset range at each width.