Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Nissan NX built from 1991 to 1993 (1600, 2000).
Every 1991-1993 Nissan NX uses a 4X100 bolt pattern with a 59.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 59.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M12x1.25. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Nissan NX (B13) and the model years each was sold. All of them share the 4X100 bolt pattern.
| Submodel | Years |
|---|---|
| 1600 | 1991-1993 |
| 2000 | 1991-1993 |
Wheel sizes Nissan fitted to the 1991-1993 Nissan NX from the factory. Offsets are ET in millimeters.
| Factory size |
|---|
| 13x5 +40 |
| 14x5.5 +45 |
| 14x6 +40 |
Widths and offsets with Verified Fitment on the 1991-1993 Nissan NX: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Offset range |
|---|---|---|
| 13-15" | 5.5" | +28 to +50 |
| 13-15" | 6" | +34 to +44 |
Wider still: 13x7 +26 to +37; 14x7 +26 to +37; 15x7 +26 to +37 fit with modifications (roll front and rear fender lips, front camber bolts (strut) for -1° or more, hub-centric rings if the wheel bore is larger).
The 1991-1993 Nissan NX (B13) uses a 4X100 bolt pattern and a 59.1 mm center bore.
Factory sizes: 13x5 +40; 14x5.5 +45; 14x6 +40.
Its wheel fasteners use a M12x1.25 thread.
Bolt-on sizes run from 13" to 15" in diameter; see the size table for the offset range at each width.